Filter
Top Products
16
Delay Wash (on some models)
You can use the Delay Wash feature to delay the start of a wash
cycle for up to 8 hours (depending on your model).
1. Load the washer and fill the dispensers.
2. Close the washer lid.
3. Press POWER.
4. Select the desired Cycle, Modifiers and Options.
5. Press DELAY WASH. 1H (one hour) will be displayed in the
time display window. The indicator light for Delay Wash will
glow.
6. For a longer delay time, press DELAY WASH. The Start time
will increase by 1-hour steps.
7. Press START. The countdown in hours to the wash cycle will
show in the time display window and the indicator light will
begin to flash.
NOTE: The Start indicator light will not flash when Delay
Wash is chosen. You must press Start to initiate a countdown
for the cycle to begin.
To change the Delay Wash time:
■ Press PAUSE/CANCEL.
■ Press DELAY WASH to select the desired delay time.
■ Press START to begin the countdown.
To cancel Delay Wash:
Press START again to begin the cycle right away or press
PAUSE/CANCEL twice.
Options
Use these pads to select the desired options for your wash cycle.
Deep Clean
This option provides enhanced cleaning action for tough stains.
The Heavy Duty cycle automatically includes Deep Clean.
Choosing Deep Clean will add approximately 10 minutes to a
cycle. Deep Clean should be started on a dry load only and
cannot be selected after the tub has started filling with water.
Deep Clean may be selected as an option with other cycles. See
table for details.
Extra Rinse
An extra rinse can be used to aid in the removal of detergent or
bleach residue from garments. This option provides an additional
rinse with the same water temperature as the first rinse. This is
the default rinse setting for the Whitest Whites cycle.
Pre Soak
Use this option for set-in stains and soil that need extra time for
removal. Soaking in this washer is different than in a conventional
washer. The washer sprays the load with water and detergent for
4 minutes at extra-low spin speed followed by a brief period of
wash action at the speed of the selected cycle. Then another
4 minutes of spraying and extra-low spinning occurs. The wash
action then pauses for the detergent to work on the soils. The Pre
Soak feature is followed by the selected cycle. Using Pre Soak
will extend your wash cycle.
End of Cycle Signal Volume
The End of Cycle Signal produces an audible sound when the
wash cycle is finished. This signal is helpful when you are
removing items from the washer as soon as it stops. Select On or
Off.
Operating Controls
Power
Press POWER to turn the washer on or off.
Start
Press START to start your washer after a cycle has been
selected. Be sure all desired Modifiers and Options have been
selected. The lid must be closed for the washer to start.
Cycle Deep Clean
(Adds time to the wash cycle)
Whitest Whites Option
Heavy Duty Default
Normal Option
Casual/Perm Press Option
Colors/Darks Option
Delicate Not available
Handwash/Wool Option
Rinse & Spin Not available
Drain & Spin Not available