Filter
Top Products
washers - insert
into inlet hoses
washers - insert
into inlet hoses
Attach inlet hoses to
water inlet valves.
connection.
ose clamp (holds
ose extension and
rain hose together)
Preparation:
Inlet hose
connection:
Panel B
)
. . . . . . . .
::::::::
. . . . . . . .
. . . . . . . .
>>:’
. . . . . . . .
/
Read and
then remove
label.
L
i
,:,:,:::::
:.:.:.:,:
::::::::::
. . . . . . . . . .
. . . . . . . . . .
;;g:i;;;
I
Remove shipping strap.
Completely remove the shipping strap
l
with 2 cotter pins from the inside of the washer.
Pull firmly to remove the other
l
Read, then remove label that
covers power supply cord and drain
connector. Peel the tape down and off
each side of cabinet.
Use new hoses and washers that came with your washer.
4
Attach hose to bottom inlet
l
valve opening first; then
second hose to top inlet, Tighten
couplings. DO NOT OVERTIGHTEN;
this could cause damage to couplings.
Elbow end of hoses attaches to
washer.
CROSSTHREAD.
3
l
Insert a flat washer into each end
of the inlet hoses. Check that washers are
firmly seated in couplings.