Filter
Top Products
C.
lo-
. For storage, wrap the
combinatic- L-- -hrl
power sup1 ’
-’
arouV hrr
thin
washer -+
GE3
11
n
Use the faucet adapter
kit that came with your
washer to modify the faucet where
washer will be used. (If you have a
Whirlpool portable dishwasher, you
do not need to modify your faucet.
The same adapter can be used.)
Remove screen holder or aerator
from end of faucet. For faucets with
external threads, stew adapter
directly onto faucet end.
If faucet has internal threads, first
install washer and threaded
bushing, then adapter screws onto
the bushing. For other faucet types,
see your Whirlpool dealer for a
special adapter kit.
Note: If washer will be used at a
faucet equipped with a spray
hose attachment, constant
pressure may cause the spray
hose to leak.To prevent potential
problems, permanently
disconnect the spray hose or
replace with a high pressure hose.
12
’
CHECK THE ELECTRICAL
REQUIREMENTS TO
BE SURE YOU HAVE THE CORRECT
ELECTRICAL SUPPLY AND
RECOMMENDED GROUNDING
METHOD. Check the Installation
Instructions to see that you have
completed each step. If you have
skipped a step, go back and
complete that step before you
continue with the following steps.
13
g
Check that all parts are
now nstalled. See
parts Irst, Panel A. If there is an extra
part, go back through the steps to
see which step was skipped.
14
Read the Use and Care
n
Guide, so you can get
the best use from your new washer.
Move the washer to the location
where it will be used.
faucet adapter
*
locking collar
m
n
Check that you have all
the tools that you started
with and that you have removed the
three shipping straps with keys from
the washer.
18
Unwind electrical
n
cord and plus into
grounded outlet. -
19
Now start the washer
n
and allow it to complete
the regular cycle.
20
When cycle is
n
completed, unplug
electrical cord, then turn water
“OFF.” Press the red bleeder button
on the connector to release water
pressure. With one hand move the
locking collar downward while
using the other hand to pull down
on the connector. Turn water
connector upside down to empty
remaining water.
4 Wrap electrical cord and
combination hose around storage
bracket.
15
n
Turn the hot water on
until it is hot. Turn faucet
‘off. Unwind combination hose from
storage bracket. Attach hose
connector to faucet by pulling down
on the locking collar while pushing
the connector over the faucet
adapter. It will snap into place.
Release locking collar.
16
Turn on the water faucet
n
slowly to the full open
position. Check for leaks. Tighten
couplings if necessary.
Permanent
installation
To permanently install your
convertible compact washer you
need the Permanent Installation Kit
285418 available from your
Whirlpool dealer.
PANEL C