Filter
Top Products
Now stikrt...
With washer in laundry area.
carton on the floor
to the right side of the
washer,
Stand in front of washer.
I Firmly grasp washer and
gently lay it right side down on
foam corners,
3
n
Slide front casters into slots at
front corners of washer,
Lightly tap casters with small
hammer until they lock in place.
4
Firmly push rear casters into
m holes at rear corners of
washer. Lightly tap casters with small
hammer until they lock in place.
Check front and rear casters again.
If casters are not locked in place,
they may fall out when washer is
moved or cause the washer to
vibrate during use.
Now stand the washer
back
UT>.
II
Read
card
Shipping strap
with key
6
Untape and open washer
I lid. Read vellow card. Place
hand on top of agitator when
removing shipping straps. Firmly jerk
then pull the three (3) shipping straps
completely out of the washer, one at
a time. Put straps close to your tools.
Remove yellow tape from the top
front corners.
7
Remove yellow card. Take
n
combination hose out
of basket,
Place hose clamp over
n
washer drain connector.
Push drain hose down over washer
drain connector, Use pliers to open
clamp and slide clamp up over
drain hose and connector. Release
clamp and check for good fit. DO
NOT KINK OR TWIST HOSES.
u
f!
D
Inlets are plastic. Do not strip
or crossthread.
9
n
Attach inlet hose to top
inlet valve opening. Tighten
coupling by hand. Use pliers to
make an additional two-thirds turn.