Filter
Top Products
9
6. Start the programme
Before starting up the machine check that:
●
the appliance is plugged in
●
the water supply tap is turned on
●
the drain hose is correctly and securely positioned
●
the door and the detergent dispenser drawer are
closed.
To start the selected programme, press
the “start pause” button; the corresponding light stops
flashing.
Only the “prewash/wash” light stays on.
The machine starts operating.
7. Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only reset it
by turning the programme selector dial to O and then
you can select the new programme.
The washing water remains in the tub.
Start the new programme by depressing the
“start pause” button.
8. Interrupting a programme
Depress the “start pause” button to interrupt a
programme which is running, the corresponding light starts
to flash. Depress the button again to restart the programme.
9. Cancelling a programme
Turn the selector dial to O to cancel a programme which
is running. Now you can select a new programme.
start
pause
10.Opening the door after the
programme has started
First set the machine to pause by pressing the “start
pause” button. If the “end” light flashes and after 2
minutes goes off, the door can be opened.
If the “end” light doesn’t flash, this means that the
machine is already heating, that the water level is above
the bottom edge of the door or that the drum is turning.
In this case the door can not be opened.
If you can not open the door but you need to open it you
have to switch the machine off by turning the selector
dial to “O”. After about 2 minutes the door can be
opened (pay attention to the water level and
temperature!).
1
1. At the end of the programme
The machine stops automatically.
If the “rinse hold” option has been selected, the phase
light “end” is on to indicate that the water must be
emptied out before opening the door.
To do this first turn the programme selector dial to “O”
and then to drain programme
8
or spin programme
7
.
The door can only be opened after the light of the
porthole has gone out.
Release of the lock is also indicated by the illumination
of the “end” light.
Turn the programme selector dial to “O” to switch the
machine off.
Remove the laundry from the drum and carefully check
that the drum is empty.
If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
132991640.qxd 06/10/2003 17:08 Pagina 9 (Nero/Process Black pellicola)