Filter
Top Products
8
Operating the Appliance
STEP ONE
SET the Temperature Control Dial to the OFF position.
STEP TWO
PLUG the unit into a proper polarized outlet.
STEP THREE
SET the Temperature Control Dial to the desired position. Leave the iron on
the hear resistant pads of the reservoir tank while the soleplate of the iron
heats for about two minutes.
STEP FOUR
When the iron has heated to the proper setting the red indicator light will go
OFF. You may begin ironing.
STEP FIVE
For STEAM – DEPRESS the Steam Button and approximately five seconds
later water will be pumped from the Reservoir into the iron, heated and burst
out from the soleplate. The blast of steam comes from the front portion of the
soleplate so position it accordingly.
When you are finished ironing, place the iron on the heat resistant pads
of the reservoir tank until it cools completely.
IMPORTANT NOTE :
The red indicator light will go ON periodically to show that the
temperature has dropped below the level desired. Simply wait for the
light to go out to continue, EXCEPT, when changing the iron from a
higher setting to a lower one. You must WAIT for the light to go ON and
then OFF again before continuing to ensure the soleplate of the iron is
not too hot.
FOR MORE INFORMATION on the types of fabrics ironed in various
settings please refer to the Fabric Chart on page 11.
Because The SteamJet Station Iron produces a burst of steam greater than
normal irons, it can be used vertically as well as horizontally.