Filter
Top Products
14
PROBLEM POSSIBLE CAUSE SOLUTION
Unit fails to steam. Light on
the On/Off Switch does not
illuminate.
Steamer is not plugged in.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse.
Plug into electrical outlet.
Reset Circuit Breaker /
Ground Fault Interrupter, or
replace fuse. If you need
assistance, contact a
qualified electrician.
Unit fails to steam. Light on
the On/Off Switch does
illuminate.
Mineral buildup in unit.
Water Tank is empty.
Follow Removing Mineral
Buildup procedure on page
13 of this manual.
Refill Water Fill Tank using
p
rocedures on page 10 of
this manual.
Water drips from nozzle.
Condensation has built up in
hose.
Extend hose vertically to
allow water to drain back
into water reservoir.
Excessive gurgling of Hose
and Steam Nozzle.
Steam output is intermittent.
NOTE: It is normal for unit
to periodically stop steaming
for a few seconds. Use
these troubleshooting tips
only if steam stays off for
longer periods.
Condensation has built up in
hose.
Mineral buildup in unit.
Some gurgling is a natural
effect of the steaming
p
rocess. For excessive
gurgling, extend hose
vertically to allow water to
drain back into water
reservoir.
Follow Removing Mineral
Buildup procedure on page
13 of this manual.
Water Filter has become
clogged or is no longer
functioning at full capacity.
Rinse filter out with clean
water. If problem persists,
replace filter using order
form on page 3 of this
manual.
Auto Shut-Off feature has
activated.
Refill Water Tank so that
water level exceeds Water
Fill Line.
T
ROUBLESHOOTING
G
UIDE