Filter
Top Products
- Ideal for removing creases from suits, jackets, skirts, hanging curtains etc
- Hang the garment on a hanger and hold the fabric slightly taut with one hand.The steam is
very hot, so you should always do this with the garment on a hanger – never while
someone is wearing it.
- Set the thermostat control to MAX (H).
- Hold the iron a few centimetres from the fabric to avoid burning delicate fabrics.
- Press the Shot of Steam button ( ) repeatedly (I), moving the iron from top to bottom.
(See illustration) (J) wait a couple of seconds between each use of the button.
H
I
J
- Press the Shot of Steam button from time to time (G)
- Wait a few seconds between each shot before pressing the button
again.
G
- The electronic system cuts off the electric power and the Auto-Stop
warning light flashes if the iron is left vertically on its heel
for more than 8 minutes, or in a horizontal position for
more than 30 seconds.
- To restart the iron, just move it gently until the warning light stops
flashing.
Note : when the Auto-Stop warning light is on,
it is normal for the thermostat light to remain off.
L
For more steam
Vertical steam ironing
Auto-Stop safety feature (depending on model)
F
Laundry can be dampened using the spray, providing there is water
in the tank.
- Whether steam or dry ironing, you are able to use the spray
button (F) to dampen laundry to remove stubborn creases.
- Make sure that there is water in the tank before using this button.
Spray Function
- Your iron is equipped with an integral anti-scale system (K).
- This system will help to provide:
• a better ironing quality with a constant flow of steam,
• lasting performance from your appliance.
K
Integral anti-scale system (depending on model)
If the soleplate temperature is too low, the iron will not produce steam because of the anti-
drip technology which prevents droplets of water leaking from the soleplate.
When using the iron for the first time, allow 2 minutes for steam to be produced.
Anti-drip function (depending on model)