Filter
Top Products
Caution
The iron can only operate with the anti-scale rod in place.
3. Use the auto-cleaning function (twice a month).
Information:
• The auto-cleaning function reduces the amount of scale in the iron.
• Set your iron to "Cordless" and fill the tank up to the MAX indicator with tap
water.
• Set the thermostat control to MAX and the steam control to DRY.
• Place your iron on its base and wait for the indicator to go out.
• Hold it above the kitchen sink.
• Set the control to AUTOCLEAN and hold it there.
• When the soleplate is warm, wipe the iron with a soft cloth.
6 - STORING YOUR IRON
INFORMATION:
• You do not have to empty the tank.
• Unplug it and wait for the soleplate to cool down.
• Place the iron on its base and set the cursor to the lock position.
Your iron is now fixed to its base. You can transport and store them easily.
• Unfasten the base from the table.
• Wind the cord around the base and fasten the clip on the cord.
Caution:
• The cord winder avoids contact between the cord and the soleplate
which may still be hot.
• Tighten the table grip again so that you can fold it back into the base.
7 - IF YOU HAVE A PROBLEM WITH YOUR IRON
PROBLEMS
AND POSSIBLE CAUSES
Your iron is producing little or no
steam.
• Your iron is new.
• In the Cordless position, your iron
needs recharging.
• The steam control is set to DRY.
• Your iron is covered with scale or
has been used dry for too long.
Water runs through the holes
in the soleplate.
• Steam cannot be produced
at the temperature you have selected.
• The iron is not hot enough.
• You are using the SuperPress control
too often.
• Your thermostat is possibly faulty.
Brown streaks come through
the soleplate and stain the linen.
• You use chemical scale removers or
demineralized water.
SOLUTIONS
When you first use it, you must wait for 2
minutes before steam becomes available.
Systematically put your iron back on its
base during ironing.
Set the Steam control to AUTO.
Clean the anti-scale rod and use the
auto-cleaning function.
Set the thermostat control
in the coloured zone (••, ••• or MAX).
Wait for the thermostat indicator
to go out.
Wait for a few seconds in between each
use of the SuperPress control.
Take your iron to an approved service
centre.
Use the auto-cleaning function
and use tap water only.
(see chapter on
"what water should be used")
Notice_089242_Mod.1690 20/07/01 16:11 Page 7