Filter
Top Products
3 - ANTI-DRIP FUNCTION
• When the iron's temperature is no longer sufficient to produce steam, the
water supply is automatically cut off so that the soleplate does not "drip".
• When you first use it, you must wait for 2 minutes before steam becomes
available.
2. Choose your ironing mode.
• Cordless: Set the cursor to CORDLESS. You can start ironing when the
thermostat indicator goes out.
Caution
• Always put the iron back on its base for maximum ironing efficiency.
Tip
• Use this ironing mode for small items and fabrics that are easy to iron.
• Cord: Set the cursor to CORD. You can start ironing when the thermostat
indicator goes out.
Tip
• Use this ironing mode for large items and fabrics that are difficult to iron
or when you use the SuperPress button frequently.
3. To smooth vertically
• Hang up the garment and stretch the fabric.
Set the thermostat control to MAX, press the SuperPress button (x)
repeatedly and move the iron from the top downwards.
Tip:
• If you have to use the SuperPress button very frequently, use the iron
with the Cord setting.
• Hold the iron a few centimetres from the fabric to avoid burning delicate
fabrics.
4. To remove resistant creases
• Press the Spray button repeatedly to wet the linen or use the
SuperPress button.
4 - DRY IRONING:
• Set the Steam control to DRY.
• You can iron once the indicator goes out.
5 - MAINTAINING YOUR IRON
Caution
Always unplug and leave your iron to cool before cleaning it.
1. Clean the soleplate
• When the soleplate is warm, clean it with a damp, non-metal pad.
Caution
• Do not use any cleaning products.
• Never hold the iron or its base under the tap.
Tip
• When you use starch, spray it on the underside of the fabric and clean
the soleplate more frequently.
2. Clean the anti-scale rod (once a month)
• Drain the iron and set the ironing control button to DRY.
• Press the anti-scale rod. Turn it anticlockwise while keeping it pushed
down.
• Release and remove the rod from its housing WITHOUT TOUCHING
THE END.
• Soak the rod for 4 hours in spirit vinegar or pure lemon juice.
• Rinse the rod with tap water. Re-insert it.
Notice_089242_Mod.1690 20/07/01 16:11 Page 6