Filter
Top Products
Using the shot of steam
The shot of steam can be used when dry
or steam ironing, when the temperature dial
is set to any temperature within the steam
band or above the two dot (
••
) setting.
1. Ensure the tank is at least 1/4 full of
water.
2. Select the desired temperature and wait
until the boost light goes out.
3. Press the shot of steam button several
times with the iron on the soleplate to
prime the pu
mp.
Note: If the tank has run dry, it may be
necessary to re-prime the pump after filling
the iron with water.
Using the spray mist
The spray mist can be used whether dry or
steam ironing to pre-dampen hard to iron
fabrics.
1. Ensure the tank is at least 1/4 full of
water.
2. Press the spray button during ironing to
release a fine mist from the spray nozzle.
The safety auto-off mechanism automatically
turns th
e iron off if you forget.
The iron will automatically shut off if left
on the heel rest (vertical) for 15 minutes,
or in the ironing position (horizontal) for 30
seconds, without being moved.(See figure 2).
The safety auto-off light on the handle will
illuminate and a warning beep will sound
to let you know that you have left the iron
unattended.
NOTE: Ultura models SR5665 and SR5560
will not produce a wa
rning beep. The Safety
auto-off light on the handle will illuminate
to indicate that the auto-off function has
activated.
After the iron has cut-out, the power ON light
will remain illuminated, as the iron is still
connected to the power outlet. Once the iron
is moved, the power will reconnect. Allow the
iron to heat until the boost light goes out,
and continue ironing as normal.
7
Using your Sunbeam Ultura Iron (continued)
The safety auto-off feature
Figure 2
15 minutes 30 seconds