Filter
Top Products
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Installation/Operation Supplement
M414881 (EN)
26
G and K Models with RM Control Suffix
1. To use an Automatic Cycle, press a
TEMPERATURE pad. Select HIGH, MED,
LOW, DELICATE or NO HEAT for items that
should not be dried with heat. A light to the left
of the selected pad lights up.
To use a Time Dry or Custom Cycle, refer to the
Programming Manual.
Figure 20
2. Select REVERSING or NONREVERSING
cylinder rotation setting.
Figure 21
3. Press START pad to start tumbler.
Figure 22
NOTE: All pads can be pressed in any sequence
without damaging control or tumbler. To stop the
tumbler at any time, open the door or press STOP.
Figure 23
NOTE: The window display will flash. Press STOP
twice (within 3 seconds) to end the cycle and reset
the control to idle status. To restart the tumbler,
CLOSE door and press START pad.
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the PUSH TO
START button must be pressed in.
4. When the cycle is complete, open door and
remove the laundry.
TMB2201N
TMB2206N
TMB2202N
TMB2203N