Filter
Top Products
Maintenance
802733
26
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Reinstallation of Shipping Materials
To prevent damage while moving the washer, the
shipping materials MUST be reinstalled.
● Disconnect washer from electrical supply.
● While supporting the front access panel, remove
two screws from the bottom edge of the panel.
● Gently lower the panel to remove it from the
washer.
● Place the shock sleeves on all four shock
absorbers. Refer to Figure 30.
● Insert hooked end of shipping brace into the open
slot of the motor mount. Refer to Figure 30.
● Attach the brace with the five bolts and washers.
Refer to Figure 30.
● Reinstall front access panel.
Figure 30
Refer to Installation section, step 6 for proper
procedures whenever the washer is moved.
Cleaning Foreign Object Trap
The washer’s pump has a trap that may collect foreign
objects. The trap may need to be cleaned if water is
draining slower than usual. To clean:
● Disconnect washer from electrical supply.
● While supporting the front access panel, remove
two screws from the bottom edge of the panel.
● Gently lower the panel to remove it from the
washer.
NOTE: The pump may have some water in it. Use a
rag or a container to catch water. If the wash drum
is full of water, use a wet/dry shop vacuum to catch
the water.
● With rag or vacuum ready, unscrew the cap on
the left side of the pump and remove trap.
● Clean the debris from the trap.
● Reinstall the trap and access panel.
● Reconnect washer to electrical supply.
FLW2124N
1 Shock Sleeves
2 Motor Mount
3 Hooked End of Shipping Brace
4 Bolts and Lockwashers
FLW2124N
2
1
4
3