Filter
Top Products
GB
3. Pull out the drain hose “A”.
Attention: if the hose is hot it means the water is hot or boiling. Place a
tray on the floor and remove the plug “B” to drain the water.
Depending on the quantity of water, it may be necessary to empty the
tray several times.
When no more water comes out, push the hose back in and screw
back the plug “B”.
4. Unscrew the screw “G” with a screwdriver and remove the metal plate “F” which prevents the pump
cover “D” from turning.
Unscrew the pump cover “D” by turning it anti-clockwise.
Clean the pump body and remove any foreign bodies.
Check the inside “E” and make sure the impeller turns freely. If there are any foreign bodies, remove
them.
5. Then screw the pump cover back on.
Position the metal plate “F” so that it prevents the cover from
turning and tighten screw “G” with a screwdriver.
Fix the drain hose by snapping the plug into place «C».
Insert the lower part of the base plate first and then push it
towards the unit until it clicks into place.
6.5 CLEANING THE DETERGENT TRAY
Keep the detergent tray free from scale.
To simplify this operation, completely remove the detergent tray (pull it out
as far as it will go, lift it slightly and then pull fairly vigorously).
Remove the traps «B» (there are two traps if the machine is not fitted with a
cover for the bleach compartment) and clean with hot water.
Put back the traps and remove any residues of detergent before putting the
tray back.
19