Smeg WDI12C Washer/Dryer User Manual


 
GB
10
3.7.2 Use of the furniture door fixing template
Proceed in the following way when applying the wooden panel to the washing dryer:
1. When f itting the f urniture door utilising the door template y ou will need to make sure that the bottom and
the top of the f urniture door will line up with the adjacent cabinet furniture doors.
2. The final positioning of the f urniture door hinges will be dictated to by the height or the plinth plus any ad-
ditional base-board used in conjunction with raising the height of the washer dryer for cosmetic purposes
3. Calculate the height of the plinth.
4. There are two holes “A” in the upper part of the template. These will hav e been perforated and are used
to mark the holes that will subsequently house the upper hinge and the insert for the closing hook. The
small central hole “B” is used to mark the position of the metal plate f ixing hole when f itting the magnetic
catch.
5. Remov e the f our pieces of protectiv e f ilm from self-adhesive areas “C” of the template
6. Position the template on the inside of the f urniture door taking in to consideration point one above.
7. Ensure that you have placed the template in the correct position making sure that it is vertically and hori-
zontally correct with reference to the guides on the template and mark the positions of the holes with a
pencil.
8. After hav ing set the template in its correct position and after hav ing also checked that is centered in a
horizontal direction with reference to the lines marked at the ends, mark the positions of the holes using
the tip of a pencil.
3.7.3 Fitting the hinge components to the furniture door
1. Drill holes in the furniture door f or the hinges, the door buffer and the closing hook, using a pedestal
mounted drill and a suitable 35mm f urniture drill bit, drill 4 number 13mm deep holes into the f urniture
door (Care must be taken not to exceed 13mm or the door f ascia could be damaged). Please note that if
the magnetic door catch is required then a small pilot hole is all that is needed
2. On the hinge side of the f urniture door drill four number 2mm x 13mm deep holes f or the hinge fixing
screws (Care must be taken not to exceed 13mm or the door fascia could be damaged)
3. Screw the two hinges “A” into the f urniture door, according to whether the furniture door is left or right-
hand hinged.