Filter
Top Products
GB
6.5 INTERRUPTING OR CHANGING THE DRYING PROGRAMME
1. To interrupt the drying programme, proceed as indicated in point 1 of paragraph 5.12 – Interrupting or
changing the washing programme. When the machine is paused, the drying time can be changed by pressing
the select button (
).
2. If you wish to stop the programme and remove the washing, you should first allow the appliance to cool. Set
drying time to 20 minutes with the select button. Start the machine as indicated in the following point and
remove the washing at the end of the cycle.
6.6 END OF DRYING PROGRAMME
Same methods as indicated in paragraph 5.13 – End of programme.
6.7 PROGRAMME FINISHED BUZZER
Same methods as indicated in paragraph 5.14 – End of programme beeper.
6.8 MODELS WITH HUMIDITY SENSOR
With automatic drying it is not necessary or possible to set the drying time; instead, simply set the moisture level
required in the dryer at the end of the drying process (A1 or A2).
Depending on the type of load in the drum and the drying level set, the humidity sensor will decide the drying time
needed to leave the laundry completely dry or slightly damp.
At the end of the drying time selection sequence (procedures described in points 6.3 and 6.4) for both drying
levels (gentle with “-“ sign and intensive with “+” sign), keep pressing the button and the following symbols will
appear on the display:
A1
Completely dry laundry, ready to be put back
in the closet
A2
Slightly damp laundry, ready to be ironed
After selecting the drying level required, continue as described in points 6.3 and 6.4.
Attention
• For drying load sizes, follow the instructions provided in point 6.1 - General Information.
21