Smeg WDF16BAX Washer/Dryer User Manual


 
GB
G
Display
The display shows the following information:
1. time remaining for the selected programme, given
in hours/minutes.
2. delayed start (for models featuring this option).
Given in hours/minutes. When the time remaining
before the programme starts is less than 60 minutes,
this information is given in minutes/seconds.
3. spin speed
4. drying times given in hours/minutes
5. cycle pause - flashing STOP
6. end of cycle - END
7. error codes
To find out which of the first 4 pieces of information are
shown on the display, check which of the LED's, C, D, E, F or
S (the latter for models featuring the delayed start option) is
lit.
H
Select spin speed button or
stop with tub full
Press the button repeatedly to select the required spin
speed. The following spin speeds are available:
0000: spin disabled and stop with tub full. The
machine does not perform the final spin and ends the
washing programme with water in the tub. To drain
the water, see the explanations shown in paragraph
5.13
from 600 rpm to the maximum speed indicated for
the model: for cotton and coloured programmes,
speed increases by 100 rpm starting from 600 rpm
up to the maximum speed indicated for the model
from 600 to 900 rpm: for synthetics, delicates and
woollens programmes, speed increases by 100 rpm
starting from 600 rpm up to 900 rpm.
I
Select programme and
drying time button
Press the button repeatedly to select drying times up to a
maximum of 2 hours (120 minutes), with increments of 10
minutes, starting from 20 minutes. The type of drying cycle
can be selected with one of the following LED's:
Delicate drying programme (letter E in this section):
drying temperature 60°C, for synthetic and delicate
garments.
Intensive drying programme (letter F in this section):
drying temperature 90°C, for cotton and coloured
garments.
L
Select programme and
drying time button enabled
LED
This LED lights up when drying times are being selected and
during the drying phase.
1
0