Instructions for Use6
Removing the Transport Brackets
The washing assembly is blocked with two metal rods which protect
the machine during transport (fig.1).
• Undo the screws on the rear wall (fig. 2).
• Remove the squares, rotate them 180° and use them to pull out
the rods (fig. 3).
• Disengaged parts may remain at the bottom since they do not
obstruct the operation of the machine (4 rubber hoses and 4 paper
spools).
• Use the enclosed plastic caps to plug the holes (fig. 4).
Save the brackets: you may need them later.
3
2
4
1