11 - EN
5 Maintenance and cleaning
Fluff filter
Lint and fibres released from the laundry to the
air during the drying cycle are collected in the
“FluffFilter”.
C Suchfibreandlintaregenerallyformed
duringwearingandwashing.Alwayscleanthe
filteraftereachDryingprocess.Youcanclean
the filter and filter area by vacuum cleaner.
Forfiltercleaning;Openthecover.Remove
the fluff filter by pulling it up and open the filter.
Cleanlint,fibre,andthefluffbyhandorwitha
softpieceofcloth.Closethefilterandplaceit
back into its seat.
Sensor (models equipped with a
sensor)
There are humidity sensors
in your machine that detect
whether the laundry is dry or not.
Forsensorcleaning;Openthe
doorofthemachine.Allowthe
machine to cool off if drying has
beencarriedout.Wipethemetalsensorswitha
soft cloth, dampened with vinegar and dry them.
C Cleanmetalsensors4timesayear.
A Never use solvents, cleaning agents or
substances alike when cleaning as these might
causefireandexplosion!
Water tank
The moisture in the damp laundry is taken from
thelaundryandcondensed.Drainthewater
tank after each drying cycle or during drying
when“Watertank”warningLEDcomeson.
A Condensedwaterisnotdrinkable!
A Never take out the water tank when
theprogramisrunning!
Watertankmaybelocatedintwodifferent
places, namely, inside the drawer on the panel
or inside the kick plate cover.
Ifyouforgettodrainthewatertank,your
machine will stop during the following drying
cycleswhenthewatertankisfullandthe“Water
tank”warningLEDwilllighton.Ifthisisthe
case,pressthe“Start/Pause/Cancel”buttonto
resume the drying cycle after draining the water
tank.
Todrainthewatertank;Carefullyremovethe
watertankbyopeningthekickplatecover/
pulling the drawer.
1 Drainthewaterbyopeningthewatertank
cover.
2 Ifthereislintaccumulationinthewatertank
cover, clean it and press to close.
3 Placethewatertankintoitsseat.
Condenser
Hot and humid air in the condenser is cooled with
the cold air from the room. Thus, the humid air
circulating in your machine is condensed and then
pumped into the tank.
C Cleanthecondenserafterevery20
drying cycles or once a month.
Tocleanthecondenser;Ifadryingprocess
has been carried out, open the door of the
machineandwaituntilitcoolsdown.Unlock
the 4 condenser locks after opening the kick
plate.Pulloutthecondenser.Cleanthe
condenserwithpressurizedwaterandwaituntil
thewaterdrains.Replacethecondenserwiththe
sidelabeled“Top”facingupwards.Lockthe4
condenser locks. Make sure that the red lock
on the upper right corner is engaged securely.
Closethekickplatecover.
Close properly and
check the locking
latchs?