Filter
Top Products
6 - EN
BThe ventilation hose should not be
connected to the chimney of a stove or
a fireplace.
BDo not operate your product at the
same time with heaters such as a coal
or gas stove. Airflow may cause the
chimney to flare up.
Connection to water drain (Products
with a condenser);
In products equipped with condenser
unit, water accumulated during the drying
cycle accumulates in the water tank. You
should drain accumulated water after
each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied
with the product instead of periodically
draining the water collected in the water
tank.
Connecting the water drain hose:
1. Pull the hose out by its end to remove
it from the product. Do not use any
tools to remove the hose. Attach the
drain hose adaptor to the end of this
hose.
2. Connect the special drain hose
supplied with the product to the hose
adaptor fitting.
3. Connect the other end of the drain
hose directly to the wastewater drain
or to the washbasin. The fitting must
always be secured in every type of
connection. Your house may flood if the
hose comes out of its housing during
water discharge.
CWhen you direct the water drain to
outside, “Water Tank” warning light will
turn on at the end of each programme.
Important:
• The hose should be attached to a
height of maximum 80 cm.
• Make sure that the hose is not pinched
or bend.
• The end of the hose should not be
bent, it should not be stepped on and
it must not be folded between the drain
and the product.
Connecting the water drain hose for
models with the water tank at the
bottom;
Connection pipe to water drain is at the
bottom rear of your machine.
1. Remove the bracket and the rubber
cap.
2. Attach the drain hose and replace the
bracket to its position.
Important:
C There is no pump in the machine, so
ensure that the hose is placed to allow
a easy water flow.
C The end of the hose should never be
higher than the level of the water outlet