Filter
Top Products
5
Install the water inlet hose
2. Connect the hot and cold water inlet hoses to the hot and cold
water faucet.
3. Connect the other ends to their respective cold and hot water inlet valve
located at the rear of the washer
Hot water needs to be at a temperature of at least 120 F- 140 F.
(49 C-60 C)for the soap to dissolve and to avoid soap residue
remaining on clothes.
Note:
C
H
Water absorption cushion
Jointer of the water inlet hose
Jointer of the
water inlet valve
C
H
Check the connection between the water inlet
hose and the water tap
1.Swaying the hose gently to confirm if it is fastened
stable.
2.After installation, open the tap to check if it leaks.
3.Do not bend the hose with overstrain.
4.Before each usage please check if the connection
between the water inlet hose and the water tap, is firm,
so as to prevent dropping from improve Installation
position.
1.Close the water tap.
2. Pull off the water inlet hose from the water tap and washer
Take down the water inlet hose
Figure 1
Figure 2
1. ttach the water inlet hoses to the hot water faucet and the cold
water faucet. Using pliers, tighten the coupling. ( As figure 1)
NOTE: Do not over tighten. Damage to the
valves can result.
Respectively a