Shark GI460 Iron User Manual


 
BEFORE FIRST USE
IRONING CHART
Remove any labels, stickers or tags which may be attached to the body or
soleplate of the garment steamer/iron before using the appliance.
Read all instructions for use carefully. Always follow the Important Safeguards.
NOTE: Before starting to iron or steam
delicate fabrics, it is best to first test the
temperature of the garment steamer/iron
on a hem or an inside seam.
To select garment steamer/iron
temperature, align temperature
selected on dial with the indicator
on the water tank.
IMPORTANT
The first time an iron is used, some odor and small white particles may come
out of the steam vents. This perfectly normal and will cease to occur after the
iron has been in use for a short while.
DIRECTIONS
ON LABEL
FABRIC
TEMP.
CONTROL
BURST OF
STEAM
P
l
e
a
s
e
n
o
t
e
t
h
a
t
o
n
t
h
e
l
a
b
e
l
m
e
a
n
s
T
H
I
S
A
R
T
I
C
L
E
C
A
N
N
O
T
B
E
I
R
O
N
E
D
!
COTTON
LINEN
SYNTHETIC
FIBERS, e.g.
acrylic, nylon
polyester
SILK
WOOL
MIN
•• ••
MAX
Set temperature
to "MAX"
Before you start using your garment steamer/iron, follow the instructions in the
manual and do the following in order to eliminate any odor and small white
residue particles and to ensure optimum steam performance.
Fill the garment steamer/iron with regular tap water.
Set the temperature control dial to its highest setting.
The pilot light will go off to indicate that the garment steamer/iron has
reached the selected temperature.
Keep the iron in a horizontal position and allow it to steam until the water runs
out.
Press the steam trigger to eliminate white residue particles.
Repeat this procedure through 2 or 3 fillings.
OPERATING INSTRUCTIONS
Before using your iron, check the
voltage and type of plug that is
required for your location. If
necessary, readjust the dual voltage
switch according to local voltage -
115/120V, 60 Hz., 230/240V, 50 Hz.
This is accomplished by sliding the
dual voltage control switch located in
the rear of the iron to the
corresponding voltage setting.
Note: The voltage selector is preset
at the factory for use on 115/120V,
60 Hz. N. A. household current.
Caution: Always disconnect the iron before adjusting the dual voltage
switch to the correct voltage setting.
3
8