Filter
Top Products
5_ Installing the washing machine
ADJUSTING THE LEVELING FEET
If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the
feet):
1. Loosen the leg bolt by turning it with your hand until it is at
the desired height.
2. Tighten the locking nut by turning it with the wrench.
• Place the washer on a sturdy, flat surface.
If the washer is placed an uneven or weak surface, noise
or vibration occurs. (Only a 1 degrees angle is allowed.)
REMOVING THE SHIPPING BOLTS
Before using the washing machine, you must remove all of the shipping bolts from the back of
the unit. To remove the bolts:
1. Loosen all bolts with the wrench before removing them.
2. Take each bolt head and pull it through the wide part of the
hole.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts for future use.
CONNECTING THE WATER SUPPLY HOSE
The water supply hose must be connected to the washing machine at one end and to the water
faucet at the other.
Do not stretch the water supply hose. If the hose is too short and you do not wish to move the
water faucet, replace the hose with a longer, high pressure hose.
To connect the water supply hose:
1. Take the L-shaped arm fitting for the cold water supply hose
and connect to the cold water supply intake on the back of
the machine. Tighten by hand.
2. Connect the other end of the cold water supply hose to your
sink’s cold water faucet and tighten it by hand.
If necessary, you can reposition the water supply hose at the
washing machine end by loosening the fitting, rotating the
hose, and retightening the fitting.
POSITIONING THE DRAIN HOSE
The end of the drain hose may be positioned in three ways:
Over the edge of a sink
The drain hose must be placed at a height of between 60 and
90 cm. To keep the drain hose spout bent, use the supplied
plastic hose guide. Secure the guide to the wall with a hook or
to the faucet with a piece of string to prevent the drain hose
from moving.
installing the washing machine
o
C
rp
m
Mi
n
Fuzzy control
Temp Spin Delay Start Function
Door open
Powe
r
Spin
Check
Remaining Ti
me
Delay Star
t
Rins
e
Wa
sh
Pre-wash
Eco
Speed
y
Wo
ol
Delicate
Synthetic
Co
tton
START
PAUS
E
12:00
WF7704NAW-02450J_EN.indd 5 2007-07-13 ¿ÀÈÄ 6:46:45