Filter
Top Products
36_ troubleshooting
troubleshooting
ERROR IMAGE MEANING SOLUTION
Water Temperature Control
Problem
The hot/cold water hose connection is
not correct.
Please connect the hot/cold water
hose connection correctly.
Power Interruption
Problem with control. Call for service.
Water Supply Problem
A fault is detected in the water level
sensor.
Call for service
A Button is either stuck or is
being pressed continuouly.
Jammed key. Call for service
The Motor is not working
properly
.
Motor problem Restart the cycle
If the code reappears, call for service
Temperature Sensor
Problem
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High/Low Voltage Detected
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
Electronic Control Problem
Communication error between SUB
PBA and MAIN PBA
Call for service
Front MEMS Sensor Problem
Front MEMS sensor problem Call for service
Rear MEMS Sensor Problem
Rear MEMS sensor problem Call for service
Excessive Suds
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
to the operation.
When it finishes washing, “End” and
“Excessive Suds” codes will blink in
turn.
To prevent it, cut down on detergents.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
WF520AB-02838A_EN.indd 36 2010-03-24 ¿ÀÈÄ 4:30:39