Filter
Top Products
Installing the washing machine _9
3. Connect adaptor to the water tap by tightening the screws
firmly.
Then, turn part (b) following the arrow and put(a) and (b)
together.
4. Connect the water supply hose to the adaptor. Pull down
part (c) of the water supply hose.
When you release part (c) the hose automatically connects
to the adaptor making a ‘click’ sound.
5. Connect the other end of the water supply hose to the
inlet water valve at the top of the washer. Screw the hose
clockwise all the way in.
• If the water tap has a screw type faucet, connect the water
supply hose to the tap as shown.
• After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square
or too big, remove the spacing ring before inserting the faucet into the adaptor.
• The appliance is to be connected to the water mains using new hose-sets and that old
hose-sets should not be used.
POSITIONING THE DRAIN HOSE
The end of the drain hose may be positioned in three ways:
Over the edge of a wash basin
The drain hose must be placed at a height of between 60 and
90 cm. To keep the drain hose spout bent, use the supplied
plastic hose guide. Secure the guide to the wall with a hook or
to the faucet with a piece of string to prevent the drain hose
from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60
cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no longer than 90 cm.
01 Installing the washing machine
a
b
c
WD6122CK-02384Q_EN.indd 9 2007-05-04 ¿ÀÈÄ 6:04:25