Filter
Top Products
12_ Washing a load of laundry
OVERVIEW OF THE CONTROL PANEL
Display panel
Displays the remaining wash cycle time, all of washing information and error
messages.
Air Wash button
Use to remove bad smells.
Selected in the sequence: Suit/Jumper Knit Coat Bedding Cancel
Wash selection
button
Use this to only perform washing or prewash.
Selected in the sequence: Main Wash
Prewash + Main Wash Main
Wash.
The washing time cannot be adjusted (for the Cotton course).
Prewash can only be selected for Cotton, Intensive, Boil, Eco-Boil, Blanket
and Towel.
Temperature
selection button
Selected in the sequence.
220 V 40˚C 60˚C Cold 40˚C
120 V 30˚C 40˚C Cold 30˚C
The water temperature varies depending on the course.
Do not allow only hot water to be supplied.
Rinse selection
button
Select this to add a rinse cycle or only perform the rinse cycle.
You can select this up to 5 times.
Spin selection
button
You can select the spin speed, if necessary.
If only the spin cycle is selected and Start/Pause is pressed in the middle of
the spin cycle, the machine starts spinning from the beginning.
The spin speed can vary, depending on the course.
No Spin means no spinning is performed after the drain.
Dry selection
button
Selected in the sequence: Cupboard
Extra Iron Light Time (30min
1:00min 1:30min 2:00min 2:30min) Cupboard.
Silver Wash
button
Silver water is supplied in the wash cycle as well as the last rinse, featuring
sterilization and antibacterial coating.
Stop&Add
selection button
Select this to add the laundry amid the process.
Delay Start
selection button
Press the button repeatedly to cycle through the available delayed start
options (up to 24 hours maximum in one hour increments).
Displayed hours means the time of finished washing-cycle.
washing a load of laundry
7
6
5
4
3
2
1
8
6
5
4
3
2
1
7
8
9
10
11
12
13
14
9
10
WD6122CK-02384Q_EN.indd 12 2007-05-04 ¿ÀÈÄ 6:04:40