Filter
Top Products
12_Setting up your washer
Setting up your washer_13
CLEAN TUB COURSE
Use this course to clean the tub. It will keep the tub clean and sanitary.
1. Press the Power button to “On”.
2. Press the Course select button three times.
3. Press the Start/Hold button.
4. Add a delicated detergent and close the lid
- Never place laundry in the tub when cleaning inside the tub, as this can cause
discoloration or damage to the laundry.
- When doing the laundry after cleaning the tub, you may find some impurities. These
are just detergent residues and impurities after the tub cleaning. Perform the rinse
cycle two to three times.
- The Soak function (20 minutes) is set automatically.
- The water level is set to Mid early on and then changed to High during the rinse.
KEEPING THE TUB CLEAN
When using the machine under humid conditions for an extended time, various bacteria from
the air may stick to the tub and form black dirt (fungi), causing damage to the human body.
To keep the tub clean and hygienic at all times, it is recommended reading “CLEAN TUB
COURSE” above and using only dedicated or recommended detergents to clean the tub
regularly at least once every one to three months.
QUICK COURSE
If you want to wash those frequently used towels or less dirty laundry time.
Because washing is speedy, it is good for light or less stained laundry.
1. Press the Power button to “On”.
2. Press the Course select button four times.
3. Press the Start/Hold button.
Water level is selected automatically. Washing, rinsing, and spinning follow. If you want to
pause, press the Start/Hold button again. You can change the course when paused.
4. Close the lid.
Water Saving COURSE
This program reduces water consumption.
Water saving, high water level, cold & hot water temperature is recommended for a normally
soiled cotton load.
1. Press the Power button to “On”.
2. Press the Course select button five times.
3. Press the Start/Hold button.
Water level is selected automatically. Washing, rinsing, and spinning follow. If you want to
pause, press the Start/Hold button again. You can change the course when paused.
4. Close the lid.
01 Setting up your washer
01 SETTING UP YOUR WASHER
SW75USPIW-02459M_EN(ÀÓ½Ã).indd 13 2009-05-28 ¿ÀÈÄ 4:34:28