Filter
Top Products
CONTROL PANEL
1. SIGNAL button
Initial mode is set to OFF at the factory, and no completion buzzer makes sound.
Push the SIGNAL button to turn the SIGNAL lamp ON and make the completion
buzzer sound.
2. TEMPERATURE button
Initial mode is set to OFF at the factory. Push TEMPERATURE button to select
LOW temperrature and turn lamp ON.
3. TIME button
TIME button displays 1:30 minutes at its initial mode. You can decrease each 10
minutes by pushing the button each one time.
(1:30 → 1:20 → 1:10→ 1:00 →
..............
30 → 20 → 1:30)
4. DELAY START button
DELAY START button is to be selected in order of 1 hour → 2 hours → 3 hours →
...
24 hours → Cancel.
5. WRINKLE-FREE button
Push Wrinkle-Free button to run COOL DOWN 10 minutes after adjusting
temperature for 10 minutes.
6. SELECTION OF CYCLE
Turn Dial to indicate cycles in the following order.
Cotton+Cupboard↔Cotton+Light ↔Cotton+Iron↔Cotton+Rotary Iron↔ Airing ↔
Synthetic+Extra↔ Synthetic+Very↔Synthetic+Cupboard↔Synthetic+Light
Synthetic+Iron↔Synthetic+Rotary Iron ↔ Airing ↔Cotton+Extra ↔Cotton+Very ↔
Cotton+Cupboard
7. FILTER lamp
Turn the system ON to let FILTER lamp flicker 3 times. When a drying cycle is fin-
ished, FILTER lamp turns ON to display cleaning instruction of filter.
8. CHILD LOCK lamp
When the system turns ON, push Wrinkle-Free button and DELAY START button in
order to turn CHILD LOCK lamp ON. From this time, all buttons do not operate. To
cancel the mode, push DELAY START button and Winkle-Free button in reverse
order.
9. START/PAUSE button
Press the button to start and pause the system.
10. POWER button
Press the button once to turn the system ON, press it once more to turn the system
OFF. When the system turns ON for longer than 10 minutes without pressing any but-
tons, it automatically turns OFF.
Operating Instructions, Tips
7
SAMSUNG Clothes Dryers Owner’s Instructions
1
2
3 4
5
6
9
10
78
During DRY cycle, displayed
remaining time may be increased
or decreased. Such a condition is
not a system failure, but a DRY
function optimization process.
Load less than 8lb to get the best
drying result.
(Max. DRY time is 3 hours.)