Filter
Top Products
operating Instructions, tips _23
Wrinkle Prevent
Selection Button
Wrinkle Prevent provides approximately 180 minutes of intermittent tumbling in
unheated air at the end of the cycle to reduce wrinkling. Press the Wrinkle Prevent
button to activate this feature.
The indicator light above the pad will illuminate when you select Wrinkle Prevent.
The load is dry and you can remove it at any time during the Wrinkle Prevent cycle.
Dry Level
Selection Button
To select the dry level in the Normal, Heavy Duty, or other Sensor Dry cycles, press the
Dry Level button. An indicator light will illuminate next to the desired dryness level. Press
the button repeatedly to scroll through the settings. Larger or bulkier loads may require
the Very Dry or More Dry setting for complete dryness. Damp Dry is designed to partially
dry items. Use for items that lay flat or hang to dry.
Temp Selection
Button
To select the correct temperature for a load, press the Temp button. An indicator light
will illuminate next to the desired temperature. Press the button repeatedly to scroll
through the settings.
High – For sturdy cottons or those labeled Tumble Dry.
Medium – For permanent press, synthetics, lightweight cottons, or items labeled
Tumble Dry Medium.
Low – For heat sensitive items labeled Tumble Dry Low or Tumble Dry Warm.
Extra Low – Provides the lowest heated dry temperature possible.
Time Selection
Button
When using Manual Dry cycles, you can adjust the time by pressing the Time Selection
button.
During the Sensory Dry cycle, the time light indicator is off because exact drying times
are determined by fluctuating humidity levels.
Adjust Time
You can add time to the automatically set times in the Manual Dry cycles (Time Dry,
Quick Dry).
If you press and hold the Adjust Time button, the time slowly increases until it reaches
the maximum time setting. When you set the time to the maximum, and you briefly
press the button, the time returns to the lowest time setting.
After selecting a preset time using the Time button, you can adjust the time using
the Adjust Time button.
For example, press the Time button to select 40 minutes, and then press the
Adjust Time button to add 5 minutes.
Start/Pause
selection button
Press to pause and restart programs.
Power button
Press once to turn your dryer on. Press again to turn it off. If you turn your dryer on and
do not touch any buttons for 10 minutes, the power automatically turns off.
02 operating Instructions, tips
6
4
8
7
9
3
5
DV365-03064C_EN.indd Sec5:23DV365-03064C_EN.indd Sec5:23 2012-06-07 7:54:482012-06-07 7:54:48