Filter
Top Products
10
WATER SUPPLY CONNECTOR FILTER
1.
Pull out the filter and wash well.
2.
Pull in the filter and connect
the hose to the inlet water
valve tightly.
inlet water
valve
3.
Check if there is a leakage.
Note to tighten up the
connector.
CLEANING THE FILTER NET
Clean the filter net often to keep the washer clean.
1. Push the upper part
of the filter and pull in.
2. Open the cover as
shown in the figure.
3. Clean the filter. 4. Close the cover and insert the
lower part of the filter in the
basket first and then push the
filter with "click" sound .
HOW TO CLEAN THE FILTER
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise
until it locks in position.
(pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the filter-cap to the left.
3.Take the filter out and
remove dirts.
4. Reassemble in
reverse order.
open
close