Filter
Top Products
Install the drain hose in the
position of about 90~100cm
above the ground.
9
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
(a)
(b)
70~80cm
Be sure to join tightly the drain
hose into the drain-outlet
on the side of the machine.
Be sure to join tightly the drain hose into
the drain-outlet on the back of the
machine.
Take out the cap-hose and
connect the outlet-hose.
IN CASE OF PUMP-DRAINED WASHER
cap-hose
ASSEMBLING THE RAT PROTECTION PANEL
1.Insert the rat
protection panel
to the assembling
hole on front side
to the end.
2.If you have difficulty
inserting the panel
lift up the washer a
little and insert it
90~100cm
1.Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
HOW TO PUT THE DETERGENT IN
Detergent Device
Put the detergent
in proportion to
water level
Softener Device
Softener
baseline
CAUTION : If softener is stored over the above base line, it may flow down at any time.
outlet-hose