- 10 -
■ CONNECTING THE WATER SUPPLY HOSE
ADJUSTMENT THE HEIGHT OF THE MACHINE
Adjust the legs to level the washer
Be careful not to put in your hand under the legs.
Pull the handles located at the right and left of the
front side and slide off.
Adjust the height of the machine upward or
downward.
When the adjustment is finished, push the handles
to fix the adjusting legs.
Waterdrop
mark
Cause How to level
The front part is
lower
Level it by adjustable legs.
The back part is
lower
Adjust the height by using the adjustable
rubber or prop at the back.
The left part is
lower
Adjust the left part by using the adjustable
legs at the front and the adjustable rubber
at the back.
The right part is
lower
Adjust the right part of the washer by
using the adjustable leg at the front and
the adjustable rubber at the back.
1. Remove the adaptor from the water supply hose.
2. First, using a “+” type screw driver, loosen the four
screws on the adaptor. Next, take the adaptor and turn
part(b) following the arrow for gap about 5mm between
them.
3. Connect adaptor to the water tap by tightening the screws
firmly. Then, turn part(b) following the arrow and put (a)
and (b) together.
4. Connect the water supply hose to the adaptor. Pull down
the part (c) of the water supply hose. When the part (c) is
released, the hose is automatically connected to the
adaptor making a ‘click’ sound.
5. Connect the other end of the water supply hose to
the inlet water valve at the back of the washer.
Screw the hose clockwise all the way in.
5-1. Connect the other end of the water supply hose to
the inlet water valve at the top of the washer.
Screw the hose clockwise all the way in.
☞ If the water tap is a screw type, assemble a water
supply hose that fits to the tap as shown.
After completing connection, if water leaks from the hose, then
repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big, remove the spacing ring
before inserting the faucet into the adaptor.
a
b
c