Russell Hobbs RHWM81400DIDB Washer User Manual


 
Installation
8
For Customer Services & Spare Parts please call 0845 208 8750
Opening times: Monday - Friday 8am 6pm & Saturday 9am 1pm or visit us at
www.productcareuk.com
Electrical connection
Your washing machine is set to 220-240V and 50Hz.
The mains cord of your washing machine is equipped with a specific earthed plug. This
plug should always be inserted to a earthed socket of 13 amps. The current value of the
fuse should be 10 amps.
We do not take responsibility for any damage that occurs due to non earthed usage.
Operating your machine under low voltage will cause the life cycle of your machine to
be reduced and its performance to be restricted.
Water
The washer should be connected to the water mains using new hose sets. Old hose sets
should not be reused. In using only one water tap or in case of only one water inlet valve,
connect the inlet hose to the cold water inlet valve.
Water inlet hose connection
Be careful not to confuse hot water inlet and cold water inlet.
Your machine has a single water (cold) inlet.
To prevent leakages on the connection joints, 1 seal is included in the hose packing, (Fit
this seal on the end of the water inlet hose at the tap side.)
After all connections are completed, check for leakages around the connection joints by
turning on your tap completely and seeing if any water escapes.
Be sure that the water inlet hoses are not folded, twisted, crushed or elongated by
stretching.