Filter
Top Products
To remove stubborn wrinkles or press in
a sharp crease, use the burst of steam
button.
Press the button firmly, a strong burst of
steam penetrates deep into the fabric.
Leave an interval of at least four seconds
between pressing the burst of steam
button.
With water in the tank, the burst of steam
button can be used as soon as the steam ironing temperature has
been reached (
● ● ●)
6
To avoid automatic switch off while the iron is heating up, always
keep the iron on its heel. Start at low temperature and graduate to
high temperature. For delicate fabrics we recommend carrying out a
test on an unobtrusive part of the garment (inner seam).
SETTING VARIABLE STEAM CONTROL
Set the variable steam control to required steam volume. Steam can
only be produced when the thermostat is in the red cotton/linen
zone. Allow iron to heat up (light goes out) before activating the
variable steam control. Reduce or set variable steam to min when
ironing at low temperatures to avoid water leakage or spitting.
Iron ready for steam ironing:
Steam is produced as soon as the iron is held
horizontally.
Steam off:
Steam generation can be interrupted by
standing the iron on its heel or sliding the
variable steam control fully to the left.
SPRAY SETTING
Ensure there is water in the tank.
Moistening the fabric with the spray will
make wrinkle removal easier.
Press the spray button down slowly for a
jet or quickly and strongly for a mist.
Do not spray silk, etc.
BURST OF STEAM