Filter
Top Products
10
1
2
3
4
5
6
7
B
S
D
B
N
V
Ty
B
E
B
b
S
B
E
B
e
d
w
R
S
D
J
m
L
d
K
B
E
None or too
little steam is
being emitted.
Steam control set on dry
position .
Turn the steam control to the
required setting area.
Not enough water in the
water tank.
Fill the water tank.
Anti-Drip* is active
(§ 12).
Wait for the soleplate to reach
the correct temperature.
The soleplate is
dirty or brown
and can stain
the linen.
Residues in the steam
chamber or on the
soleplate.
Use the Self Clean function then
clean your iron.
Use of chemical
descaling agents.
Do not add any descaling agents
to the water in the water tank.
Use the Self Clean function and
clean your iron.
Pure distilled/demine-
ralised or softened water
is being used.
Only use untreated tap water or
mix half tap water with half
distilled/demineralised water.
Use the Self Clean function and
clean your iron.
Use of starch. Always spray starch onto the
reverse side of the fabric to be
ironed and clean your iron
soleplate.
Iron is leaking. Soleplate temperature
too low or overuse of
extra long shot of steam
button.
Set the temperature control to a
higher temperature and allow
more time between each shot.
If you are unable to trace the cause of the fault, contact an official
Rowenta Customer Service Centre. The addresses are shown in the
enclosed service centre address list. Helplines listed at the front of
this leaflet.
Further hints and tips are obtainable from our homepage:
www.rowenta.com.
Subject to modifications !
* depending on model *
DZ9000-11038999469 2/03/06 14:29 Page 10