Rowenta DZ9030 Iron User Manual


 
8
C
se
p
ir
U
W
1
W
c
w
T
t
t
T
c
o
a
Y
a
P
13 • Automatic electronic 3-position shut off
If, although switched on, the appliance is not moved, it will
automatically switch off and the auto off light will blink after
the following intervals (fig.17):
- After 30 sec., if the iron is standing on the soleplate or lying on its side.
- After 8 mins., if the iron is standing on its heel.
AFTER USE
14 • Emptying
Unplug the iron (fig.4), pour away remaining water (fig.18) and set
steam control to .
Open and close the steam control several times (fig.19) to prevent
the drip hole into the steam chamber from furring or blocking up.
15 • Storing
Allow the appliance to cool down before storing the iron standing
on its heel
(fig.20)
.
MAINTENANCE AND CLEANING
16 • Anti-scale system
Your iron contains an anti-scale cartridge to reduce scale deposits.
This considerably prolongs the operational life of your iron.
The anti-scale cartridge is an integral part of the water tank and
does not need to be replaced.
17 • Self Clean function
(prolongs the life of the iron)
The Self Clean function flushes dirt and scale particles out of the
steam chamber. Fill the water tank with tap water up to the max
mark and heat the iron to the ••• temperature. Unplug the iron and
hold it over a sink horizontally. Hold the steam control into the Self
IMPORTANT Do not wind the cord around the hot soleplate.
Never store your iron placed down on the soleplate
(fig.20).
IMPORTANT Unplug and allow the iron to fully cool down
before maintenance and cleaning.
IMPORTANT Do not use descaling agents, as these damage the
lining of the steam chamber and so may impair the steam function.
*
DZ9000-11038999469 2/03/06 14:29 Page 8