Filter
Top Products
BEFORE USE
˾
Please read all of the instructions for use and the Important
Safeguards carefully.
˾
Remove all packaging from the generator.
˾
It is normal for a small amount of smoke and a light odor to
be produced the first time it is used. This will quickly
disappear.
HELPFUL HINTS
˾
Before using the generator for the first time or if you have
not used the steam function for a few minutes, press the
steam button several times in a row while holding the iron
away from your clothes. This will enable any cold water to
be removed from the steam connection cord.
˾
When ironing start with fabrics that require a low
temperature setting (
●) and finish with those which need
the highest temperature (
● ● ●).
˾
Mixed fiber fabrics should be ironed on the temperature for
the most delicate fabric. For example a shirt that is 60%
cotton and 40% polyester should be ironed at the (
●)
setting for synthetics.
˾
If spray starch is used, spray it onto the reverse side of the
garment. Allow starch to penetrate before ironing.
˾
For best results, use a mesh type ironing board to allow
excess steam to escape.
˾
For delicate fabrics, we recommend carrying out a test on
an unobtrusive area of the garment such as an inner seam.
FILLING THE BOILER
The steam generator is designed to operate using tap water.
Please review Water Recommendations section for additional
water information.
1. While unplugged, place the
steam generator on a stable,
horizontal, heat resistant surface.
2. Unscrew the boiler cap.
3. Using a water pitcher, fill with
33oz. of water. Do not fill water
tank past the base of the boiler
cap thread. Do not overfill. Be
sure that water does not spill
over. If this occurs remove the
excess water.
4. Replace the boiler cap and screw
it on tightly.
To fill boiler while you are using the appliance see section
Filling Boiler While In Use.
TURNING ON AND OFF:
1. Plug the generator into a 120 volt
electric outlet.
1. DG560 model: Press the on/off
switch (A) on the control panel
and the steam indicator light will
turn on. Adjust the temperature
control dial on the iron to heat
the soleplate. The temperature
indicator light will light up on the
iron.
(A)