Filter
Top Products
The temperature indicator light will light up on the iron as
it is heating.
DG 580 model: Press both on/off switches (A) and (B) so
that the iron light and steam indicator light turn on.
3. When the steam indicator light turns off (approximately 7
minutes), steam is ready.
4. Hang the garment on a coat hanger and hold the fabric
slightly taut with one hand.
5. Holding the iron in a vertical position, press continuously
on the steam button while moving the iron from the top of
the garment to the bottom.
FILLING THE BOILER WHILE IN USE
Caution: NEVER UNSCREW THE BOILER CAP WHILE
IRON IS PRODUCING STEAM AND BOILER IS
UNDER PRESSURE.
1. Before opening the boiler, ensure that there is no steam
inside. To do this, press the steam button and keep it
pressed until there is absolutely no more steam.
2. Turn the unit to off (see section Turning On and Off) and
unplug from outlet.
3. Slowly unscrew the boiler cap. Using a water pitcher, fill
with 33 oz. of water. Do not fill water tank past the base of
the boiler cap thread. Be sure that water does not spill over.
If this occurs remove the excess water.
4. Replace the boiler cap and screw it on tightly.
5. Plug back in to electrical outlet.
AFTER IRONING
1. Turn the unit off. (Consult section Turning On and Off.)
2. Unplug the appliance.
3. Place the iron on the iron rest and allow to cool completely
which will take approximately 1 hour.
4. Once cold, empty water from the appliance before storing.
We recommend emptying the boiler when not in use.
CLEANING AND MAINTENANCE
Before cleaning ensure that the appliance is unplugged
and completely cooled down.
The iron can be cleaned with a damp cloth and wiped dry.
Never use household cleaners, descalers or solvents.
CLEANING THE SOLEPLATE
˾
In normal use a draggy coating may build up on the
soleplate (starch, detergent buildup, burnt synthetic fibers).
This can be easily removed by using the Rowenta Soleplate
Cleaning Kit or a quality hot iron soleplate cleaner available
at most stores.
˾
To prevent scratching of the soleplate, do not iron over
sharp objects (zippers, etc.).Do not place the iron on rough
surfaces, e.g. metal iron support, which may scratch the
soleplate. Place the iron on its rest on top of the base of
the unit.
˾
Always put the iron with the soleplate down on the iron
rest, never place on its heel.