Filter
Top Products
2 • PREPARING YOUR IRONING CENTRE
1. Always place your ironing board on the floor in a horizontal position. (1)
2. Hold down the ironing board feet under one of your own feet. (2)
3. Use your hand to press the semi-automatic opening lever located underneath the front end of
the board, then raise the board to the required height (2).
4. If the board is too high for comfort, adjust its position using the adjuster lever (3).
5. Lift up and remove the water tank.
6. Unscrew the water tank cap.
7. Fill the water tank, taking care not to exceed the maximum level. (4)
8. Replace the cap on the water tank.
9. Replace the water tank in its housing, pressing down until it clicks into place (5).
98 cm
70 cm
Suitable water:
Your steam generator has been designed to operate using untreated tap water. However, if
your water is very hard, mix 50 % untreated tap water with 50 % distilled water.
The ironing centre comes with a tester that can be used to test the hardness of the water.
Unsuitable water:
Do not add anything to the contents of the removable water tank, and do not use water
from clothes-dryers, scented or softened water, water from refrigerators, batteries or air
conditioners, pure distilled water, pure demineralised water or rainwater, as these types of
water contain organic waste or mineral elements that become concentrated when heated
and cause spitting, brown staining or premature wear to the appliance.
(1)
(2)
(3)
(4)
(5)