Filter
Top Products
Before you call for service
If you are having an operating problem,
check this chart to see what might be
the cause before you call for assistance.
Problem
Check if
What to do
Dryer will Power cord is plugged into a live circuit with
not run. proper voltage.
Turn cycle control knob to OFF. Firmly plug cord into
electrical outlet. Check circuit voltage at fuse/circuit
breaker box. Reset controls and push start button.
Dryer door is closed.
Start button is pushed firmly.
Controls are set in a running or ON position.
Home’s main fuse has blown or circuit breaker
has tripped. Also check if a time-delayed
fuse or circuit breaker has been used.
Close door firmly.
Push start button.
Set controls and push start button.
Turn cycle control knob to OFF. Replace fuse with a
time-delay fuse of the correct capacity.
Reset circuit breaker. Reset controls and push start
button.
Dryer will
not heat.
Gas shutoff valves are open both on dryer and
on supply line.
Cycle control knob or temperature selector is
set on NO HEAT/FLUFF.
Heat cycle is in its last minutes. (There is no
heat during that time.)
Turn cycle control knob to OFF. Open gas valve. Wait 5
minutes. Reset controls and push start button.
Reset cycle control knob or temperature selector to
heat setting.
Wait for cycle to finish.
Home’s main fuse has blown or circuit breaker
has tripped. Also check if a time-delayed
fuse or circuit breaker has been used.
Turn cycle control knob to OFF. Replace fuse with a
time-delay fuse of the correct capacity.
Reset circuit breaker. Reset controls and push start
button.
An electric dryer circuit uses 2 breakers or 2 fuses.
If one breaker has tripped or one fuse has blown,
the dryer may run, but not heat.
Gas shutoff valves are open both on dryer and
on supply line.
Turn cycle control knob to OFF. Open gas valves. Wait 5
minutes. Reset controls and push start button.
Drying time
Lint screen clean.
Clean lint screen. See instructions on Page 10.
too long.
Page 11