Roper AL2121W Washer User Manual


 
Select water level
Select cycle and water
temperature
Select wash time
To set the correct water level, turn the
water level selector knob to the level
that describes the size of your wash
load.
The water level can be set to SMALL (a
few small items) or LARGE (a full load).
NOTE:
For best results with permanent
press clothes, use the LARGE water
level.
Reduce wash time when using the
SMALL water level setting. Loads with
only a few small items need less wash
time for best results.
Wash cycles
Regular Heavy (14 min.)
Wash sturdily
constructed fabrics (i.e. cotton) or
heavily soiled items.
Regular Normal (6 min.)
Wash moder-
ately soiled fabrics.
Permanent Press (10 min.)
Wash
moderately soiled permanent press and
some synthetic fabrics. Cool-down rinse
helps to keep fabrics from wrinkling.
Permanent Press (6 min.)
Wash lightly
soiled permanent press and some
synthetic fabrics. Cool-down rinse helps
to keep fabrics from wrinkling.
To set the water temperature, push in
the cycle control knob and turn it
clockwise to the area marked H (hot),
W (warm) or C (cold). Set water
temperature level according to fabric
label or the amount of soil to be washed.
NOTE:
All rinses use cold water.
Start the washer by pulling out cycle
control knob. The washer will fill to the
level you set with wash water of the
selected temperature.
After filling, stop
the washer by pushing in cycle control
knob.
Select wash time
Laundry Tip
For best cleaning results, use:
-Hot wash water for normally
soiled, permanent press and
synthetic items; white and color-
fast cottons; heavy soils and
diapers.
-Warm wash water for knits; dark
or non-colorfast colors ; washable
woolens; moderate soil.
-Cold wash water for lightly soiled
fabrics; some non-colorfast colors.
Dry detergents can spot-fade wet
laundry. If using cold water, dissolve
recommended amount of detergent
in one quart (1 L) of warm water
before adding it to the washer, or
use a liquid detergent.
Select a wash time by stopping the
washer after filling. Turn cycle control
knob to the number in the wash cycle
you want. The numbers are minutes of
wash time. Restart the washer.
To start
Pull cycle control knob out. The washer
will agitate for a selected number of
minutes. Agitation can occur with the
washer lid up or down. The washer will
pause briefly throughout each cycle.
These pauses are normal for washer
operation.
To stop at any time
Push cycle control knob in. To restart,
pull cycle control knob out.
Page 5