Filter
Top Products
Vertical Shot of Steam (types GC2225, GC2220, GC2215,
GC2130, GC2125, GC2120 and GC2115 only)
C
1 The Shot-of-Steam function can also be used when you are
holding the iron in vertical position.This is useful for removing
creases from hanging clothes, curtains, etc.
Never direct the steam towards people.
Drip Stop (types GC2225, GC2220, GC2130 and GC2125
only)
This iron is equipped with a drip stop function: the iron automatically
stops steaming when the temperature is too low to prevent water from
dripping out of the soleplate.When this happens you will hear a click.
Automatic shut-off (types GC2225 and GC2130 only)
An electronic safety device will automatically switch the heating
element off if the iron has not been moved for a while.
C
◗ To indicate that the heating element has been switched off, the
red auto-off pilot light will start blinking.
To heat up the iron again:
1 Pick up the iron or move it slightly.
2 The red auto-off pilot light will go out.The amber temperature
pilot light will go on, depending on the soleplate temperature.
3 If the amber pilot light goes on after the iron has been moved,
wait for it to go out before you start ironing.
4 If the amber light does not go on after the iron has been
moved, the iron is ready for use.
Cleaning and maintenance
Calc-Clean
The Calc-Clean function removes scale and impurities.
Use the Calc-Clean function once every two weeks. If the water in
your area is very hard (i.e. when flakes come out of the soleplate
during ironing), the Calc-Clean function should be used more
frequently.
ENGLISH8