Oreck JP777 Iron User Manual


 
When using an electrical appliance, basic precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE
WARNING
To reduce the risk of fire,
electric shock, or injury:
• Never switch the dual voltage selector while the appliance is in use.
• This appliance was set at the factory to operate at 120 volts. Refer to the
General Information section of this manual for conversion to 230 volt operation.
• Empty water from the iron before storing it. Point the unit downward over a
sink and turn upside down to drain. Push steam button a few times and lightly
shake iron after use to ensure all water is drained. The remaining moisture will
evaporate if the unit is plugged in and heated for a few moments.
• If an extension cord is absolutely necessary, a 15-ampere cord should be
used. Cords rated for less amperage may overheat. Care should be taken to
arrange the cord so that it can not be pulled or tripped over.
SAVE THESE INSTRUCTIONS
Household Use Only
ALL SERVICING SHOULD BE DONE BY AN
AUTHORIZED ORECK SERVICE CENTER.
CUSTOMER SERVICE HOT LINE
US: 1-800-989-3535 Canada: 1-888-676-7325
2
IMPORTANT SAFETY
INSTRUCTIONS CONTINUED
Warranty
Oreck Corporation warrants the Travel Iron/Steamer (Model JP777) free from defects in
material and workmanship under normal, non-commercial use and service. Oreck will
remedy any such defects if they appear within one (1) year from date of purchase. This
warranty gives you specific legal rights, and you may have other rights, which vary, from
state to state.