Filter
Top Products
5
FILLING
A
1 Make sure that the iron is not
plugged in, then set the steam
dial ‹ to ‘
O
’ position D before
filling the iron with water.
2 Lift the filler cap › until it locks
and holds in the open position.
Fill water through the filling hole
into the water tank ‚, using a
suitable container A.
The tank holds 350ml of water.
The iron is fitted with a clear
view water tank, so you can
easily see the water level when
filling. During filling, tilt the iron
forward to read the water level.
The ‘MAX’ mark is printed on
the side of the clear view tank
B.
After filling, push the filler cap
forward until it clicks in place.
IN HARD WATER AREAS, THE
USE OF DISTILLED OR
DEMINERALISED WATER IS
RECOMMENDED.
Never use battery topping up
fluid or water containing any
substances like starch, or
sugar, or defrosted water
from a refrigerator.
3 Always pour out the remaining
water after use.
WARNING: When filling your
iron with tap water, always
use a suitable container.
Never fill directly under the
tap.
TEMPERATURE
CONTROL
C
1 Plug in the iron and switch on
the power at the mains socket.
2 Set the temperature dial ‡ to
the temperature required C, but
don’t start ironing immediately. If
you wait a few minutes, the iron
will stabilise at the required
setting.
• Your Morphy Richards iron is
fitted with a temperature
indicator light · which will
switch on and off whilst you are
ironing. This is perfectly normal
as it shows that the iron is
maintaining the heat setting you
have chosen.
• It is always a good idea to begin
with cool fabrics and work up to
higher settings. An iron heats up
quicker than it cools down so
you will save time and energy.
X
A
M
N
E
N
I
L
N
O
T
T
O
C
L
O
O
W
N
O
L
Y
N
K
L
I
S
N
I
M
C
A
For details of other Morphy Richards products, please see our website:
B
MAX level mark
RN40854MUK Rev1_Instruction Booklet 15/09/2010 16:20 Page 5