Morphy Richards ELITE PRO Iron User Manual


 
8888
4 Depress the steam button
for 1
minute to clear the system of air (first
time use only). This will be
accompanied by a clicking noise
which is quite normal.
5 Begin first time ironing with an old
towel. Note: If you press the steam
button before the steam generator
reaches it’s required temperature, a
warning double beep will sound.
6 The appliance is ready to use.
7 Press the steam button
for steam
ironing.
8 Depress the power switch
ÁÁ
to turn
off the base unit when ironing is
complete.
MODELS WITH
SPRAY FEATURE
Certain models are fitted with a
spray feature. Stubborn creases and
excessively dry clothing can be
softened by damping the material
with water. This procedure means
ironing can be achieved without
applying excessive pressure.
Filling
CC
To fill the tank with water, press the
release button
ÔÔ
and lift away the
spray unit
ÌÌ
.
Pull the tank
away from the spray
unit in a downward direction, taking
care not to damage the tank, and fill
water to the ‘Full’ mark.
Re-assembly
CC
Attach the tank to the spray unit,
taking care to align the parts
correctly.
Locate the spray unit to the front of
the iron and press it home until the
unit locks into place.
Press the pump
ÓÓ
a few times to
purge the air from the system, when
a fine mist of water is created, the
unit is ready for use.
Dry ironing
1 Connect the appliance to a suitable
mains outlet.
2 42288, 42297, 42298 & 42299: Press
the steam switch
ÎÎ
2 times until all
three steam level indicator lights go
off (steam off mode).
3 Turn the temperature dial
on the
iron in a clockwise direction, select
dot-1, dot-2, or dot-3 according to
the recommendation of the garment
label.
4 The temperature indicator light
¤¤
glows on the iron, indicating that it is
switched on.
5 When the required temperature is
reached, the temperature indicator
light on the iron goes off. The iron is
ready to use.
It is always a good idea to begin with
‘cool’ fabrics and work up to higher
settings.
An iron heats up quicker than it
cools down so you’ll save time and
electricity.
Auto-shut off
(42288, 42297, 42298 & 42299)
An auto-shut off system will activate
if the steam is not used for over 15
minutes. The mains indicator light
ÁÁ
will flash between green and red
indicating the unit is in ‘sleep mode’.
When this occurs, press the steam
select button
ÎÎ
or the power switch
ÁÁ
‘ON’ once. The appliance will
switch on immediately and you need
to check, and select, the required
setting.
ANTI-SCALE SYSTEM
The anti-scale cartridge is designed
to reduce the build-up of limescale
which occurs during steam ironing,
this will prolong the working life of
your iron. However, please note that
the anti-scale cartridge will not
completely stop the natural process
of limescale build-up.
When the cartridge needs replacing,
the indicator light
ÂÂ
will flash.
NOTE: The unit will not switch off,
but you need to replace the cartridge
as soon as possible.
CC
Ó
Ô
Ì
UUKK HHeellpplliinnee 00884444 887711 00995533 RReeppllaacceemmeenntt PPaarrttss 00884444 887733 00771199 IIrreellaanndd HHeellpplliinnee 11880000 440099 111199
42288 rev4 14/3/08 11:14 Page 8