Filter
Top Products
55
Temperature
control
BB
• Default setting + 3 dot (cotton).
• To increase the temperature,
press the arrow .
• To decrease the temperature,
press the arrow .
• The temperature console
··
will
flash to indicate that the iron
has not yet reached the correct
temperature.
• Once the correct temperature
has been reached, the light will
stop flashing and there will be
one ‘beep’ to signal that the iron
is now ready for use.
FEATURES OF YOUR
IRON
Dry ironing
You can use your iron as a dry
iron only. Make sure the variable
steam control
‹‹
is set to the ‘0’
symbol.
Any temperature setting may be
used depending on the
garment. The spray feature may
be used, providing there is water
in the tank (see filling section).
You do not need to put any
water in the tank when dry
ironing only.
Spray
CC
Press the spray button
¤¤
and
aim the spray of water at
stubborn creases. You can do
this whilst dry ironing, providing
there is water in the tank. When
using the water spray, it may be
necessary to push the button a
few times to get the spray pump
primed.
Variable steam
DD
Fill the iron with water,
as described in ‘Filling’
on page 4, and insert
the plug into the
electrical socket.
The steam output can be varied
from low to high by moving the
variable steam control
DD
.
The steam facility should only
be used on garments which are
suitable for ironing at the 3 dot
and MAX setting.
Shot of steam
EE
Press the shot of steam
button
⁄⁄
to obtain a
burst of extra steam for
ironing out creases in
heavy material such as
denim etc.
The shot of steam can be used
whilst dry ironing, providing
there is water in the tank, and
the temperature control is set
within the steam range.
Do not use the shot of
steam at temperatures
below the steam range
shown on the control
dial.
Note: For optimum
steam quality, do not
operate the shot more
than three times in
succession.
BB
Increase
temperature
Decrease
temperature
CC
Steam off
‘MAX’ steam
DD
55
EE
40692 rev2 20/6/08 14:32 Page 5