Filter
Top Products
What to do, if . . . Cause . . . Remedy . . .
. . . the “Check (water) inlet"
indicator flashes during the
programme but the pro-
gramme is running normally.
The water inlet is restricted.
– The stopcock is not opened
far enough.
– The inlet hose is kinked.
– The water pressure is too low
– The filter in the inlet hose is
dirty. Clean it.
. . . the “Check (water) inlet"
indicator flashes and the
laundry was not washed.
The water inlet is closed.
– Open the stopcock.
– Start the programme again.
. . . one of the following indi-
cator lights is flashing
–“Soak/Pre-wash”
–“Main Wash”
–“Rinses”
–“Rinse hold”
There is a fault.
– Press “I-ON/0-OFF” button to
release it.
– Turn the programme selector
to "Finish".
– Press “I-ON/0-OFF” button in.
– Re-start the programme.
– If the indicator light starts
flashing again, call the
Service Dept.
Problem solving guide
40