Filter
Top Products
Reminder to remove transit bars
To avoid the risk of damage, the
transit bars must be removed before
the machine is used for the first time.
See "Installation and connection" for
instructions on how to do this.
^
After removing the transit bars (if this
has not already been done by your
fitter) press the right hand Menu
button under OK.
Running your first programme
Your machine is now ready for the first
programme to be run.
15:00
Select programme
^ Press the Cottons programme button.
^ Press the Start/Stop button.
^ At the end of the programme switch
the machine off.
Before you can use the washing
machine, the load sensor has to be
calibrated to zero as you would with
bathroom scales.
Calibrating the load sensor to zero
^
Switch on the washing machine.
^
Open the drum door.
^
Press the Cottons programme button.
^ Press and hold the Load/Detergent
button pressed in until the following
message appears in the display:
:
Zero setting
OK
^
Switch off the washing machine.
The machine is now ready for use.
Before using for the first time
15