Miele W 1966 Washer User Manual


 
The program runs normally but a fault indicator lights up.
What if … Possible cause Fix *
the "Check drain" indica
-
tor blinks?
The drain is blocked. Clean the lint trap and the
drain pump.
the "Water intake" indica
-
tor blinks?
The water intake is
impaired.
Check whether:
the water valve is open.
the inlet hose is kinked.
The inlet hose filter is
dirty.
Clean the filter under run
-
ning water and carefully
remove any large particles.
the "Oversudsing" indi-
cator lights?
The machine has
oversudsed.
Run a drain cycle.
Only use the recommended
amount of a high efficiency
detergent.
the "Main Wash" indica-
tor blinks in the program
sequence display?
There is a fault. Start the program once
more.
If the fault message ap-
pears again call Miele’s
Technical Service Depart-
ment.
the "Anti-crease/End" in
-
dicator blinks in the pro
-
gram sequence display?
The program selector
was moved to a differ
-
ent setting after the
program started.
Turn the program selector to
the original position.
* To turn off the fault indicator light: Turn off the washer with the "On/Off" button
and turn the program selector to "End".
Frequently asked questions
27