Filter
Top Products
Problem solving guide
Any work done on the electrical components of this appliance should
only be performed by a qualified and trained person in accordance with all
local and national codes and regulations. Unauthorized repairs may result
in personal injury and damage to the machine.
What to do if, . . . Cause . . . Remedy . . .
. . . The programme does not
start?
There is no power.
The “ON” indicator lamp has
not lit up.
Check that..:
– the door is properly closed.
– the machine is plugged in.
– the fuse or circuit breaker
has not tripped.
There is power and the “ON”
indicator lamp is on, but the
programme selector has not
been turned to the “Start/Finish”
position.
– Turn the programme selector
to the “Start/Finish” position.
– Select a programme.
. . . The “Check p / q” indi-
cator lamps are flashing?
The “Check p” indicator lamp
is flashing, and the programme
has started.
The water inlet is blocked.
– The inlet valve is not opened
far enough.
– The inlet hose is kinked.
– The water pressure is too
low. Call the Service Dept.
The “Check q” indicator lamp
is flashing.
The drain is blocked.
– Clean the drain pump and
lint trap.
– Has the drain hose been
installed too high? (max drain
height = 4 feet)
Problem solving guide
31